Dear ISIS users, Has any of you used warmabs model before in ISIS ? If so perhaps you encountered a problem which I'm having at the moment. After setting up all the variables necessary (warmabs_data, warmabs_pop) I load the model, try to fit it but the final values of the parameters in the model (e.g. nh,xi,vturb) don't seem to change with respect to the initial values I put in (which are already somewhat close to the good fit but not there yet). The parameters I mention are free of course during the fit. I'm more familiar with xspec and the same warmabs model is working without problems there. I tried playing around with relstep in set_par. It seems to make a difference if I increase the relstep to 0.1 for example though I'm actually not sure if this is a good solution. Perhaps some of you encountered this problem before and know how to sove it ? I'd be very grateful ! Cheers, Oliwia Madej ------------------------------------------------ Oliwia Madej Netherlands Institute for Space Research, Sorbonnelaan 2, 3584 CA Utrecht +31 (0)88 777 5839 ------------------------------------------------ ---- You received this message because you are subscribed to the isis-users list. To unsubscribe, send a message to isis-users-request_at_email.domain.hiddenwith the first line of the message as: unsubscribeReceived on Thu Jun 06 2013 - 05:27:55 EDT
This archive was generated by hypermail 2.3.0 : Fri May 02 2014 - 08:35:47 EDT